Network configuration
45
Method Description Note
DIP switch
(S1)
By default, the IP address is defined by
software. Setting any DIP actuator to ON
enables hardware selection. DIP actuators
1 to 8 define the last octet (1 to 254) of the
IP address in binary. Actuator 8 represents
the least significant bit.
Only read at
start-up.
Only for intranet
use.
IP address: 192.168.0.xxx
Subnet mask: 255.255.255.0
Gateway: 0.0.0.0
where xxx stands for a value between 1 and
254 and is selected by DIP switch S1.
Example DIP settings:
DHCP/BOOTP Automatically receive the configuration from
a DHCP server.
A DHCP server
is required on
the network.
Intranet IP
address
S1 actuator
positions
(Selected by
software)
OFF oooooooo
ON
12345678
192.168.0.1 OFF ooooooo
ON o
12345678
192.168.0.2 OFF oooooo o
ON o
12345678
• • • • • •
192.168.0.255 OFF
ON oooooooo
12345678
To Next Page
Loading...
