ABB RTU500 series - 1 Introduction; Preface; Structure of this Document; References

RTU500 series Remote Terminal Unit Introduction
Preface
ABB AG - 1KGT 150 924 V000 1 | 1-1
1 Introduction
1.1 Preface
The document describes the requirements and installation steps needed to build up a full RTU500
series engineering environment. The base configuration of the Microsoft Windows Operating System
and the tools required for the engineering process are described. System requirement are defined
in chapter Chapter 2.7 in figure "Fig. 28: Page for general information and pre-requisitions" .
1.2 Structure of this document
This document is divided in two main parts:
The first part describes the RTU500 series Web server functionality:
The first part describes the RTU500 series Web server functionality:
•
Management functions:
– Configuration management
– Firmware management
– User management
– Loading of password files
– Help page
•
Diagnosis functions
– System logs
– Process diagnosis functionality (Hardware Tree)
– The Network Tree
•
Test & Simulation functions
– Enable Logging and Debugging functions
– Test mode functions
•
Operation functions
– Starting the Integrated HMI
– File archive functions
•
Engineering
– Changing individual parameters online
– Onlne generation of a new RTU configuration
The second part includes the installation and configuration of the environment.
•
PPP Installation
•
USB Installation
•
Establishing the connection
•
Network configuration
•
The hardware required for the connection
1.3 References
Additional Information is available in the documents: