ABB SACE Emax 2 - Page 24

ABB | SACE Emax 2
22 | © 2019 ABB | 1SDH001316R1002 - ECN000086501 - Rev. A Interface and menus | 4 - Menu
Settings Menu
Menu Submenus Description and parameters
Circuit Breaker
Configuration Phase number selection
Hardware Trip Protection activation command
T Protection Protection activation command
Neutral Protection
(2)
Enable, Neutral threshold
Earth protection
(7)
External sensor configuration
Installation Installation of modules
Main Frequency - Grid frequency configuration
Phase Sequence - Phase sequence configuration
Modules
Local/Remote Parameter writing configuration
Local Bus Configuration of local bus presence
Modul x
(3)
Details in chapters of each module
BLE LV communication configuration
Functions Switch On LOCAL, Signalling RESET
Monitor time - Measuring range configuration
Test Bus - Test bus activation
Power Controller
(4)
Enable
(5)
Function enabling and parameters: see manual
1SDH001330R1001
-
Load Shedding
(4)
Enable
(5)
Function enabling and parameters: see manual
1SDH001330R1001
-
Network Analyzer
(6)
Enable
(5)
Function enabling and parameters: see manual
1SDH001330R1001
-
Datalogger
(6)
Enable
(5)
Function enabling and parameters: see manual
1SDH001330R1001
-
Dual Set
(6)
Enable
(5)
Function enabling and parameters
Default set
System
Date Configuration of unit date
Time Configuration of unit time
Language Configuration of menu language
New PIN PIN Configuration
View -
Representation parameters of menus
and measurements: see manual
1SDH001330R1001
Functions
YO Command
Function, Delay
YC Command
Maintenance Alarms Activation of maintenance signals
(1)
with CB in 3P configuration
(2)
available with CB in 4P or 3P with neutral configuration
(3)
the menu populates with the list of accessory modules detected by the unit with Local Bus activated and in
the envisaged connection and supply conditions
(4)
available if the function has been installed in the Trip unit
(5)
additions are only made to the list of the specific submenu when the function is enabled (=On)
(6)
available if provided for by Trip unit model or if relative SW package has been activated
(7)
available with LSIG versions