ABB SACE Emax E4.2 - Page 15

ABB | SACE Emax 2
Circuit-breakers E1.2-E2.2-E4.2-E6.2
4 - Guide to the product choice
12 | © 2023 ABB | 1SDH001330R1002 - ECN000297030
Electrical and mechanical
accessories
Electrical signalling
Open/closed auxiliary contacts - AUX
Ready to close signalling contact - RTC
Ready to close signalling contact Ekip – RTC
Ekip protection trip unit tripping signalling contact – S51
Remote resetting - YR
Service trip units
First and second opening coil - YO
First and second closing coil - YC
Undervoltage coil - YU
Motor operator
Motor
Protections
Protection device for opening and closing push buttons - PBC
Compartment door flange
Terminal-covers and separators
High terminal-covers - HTC
Low terminal-covers - LTC
Phase separators PB
Other accessories
mechanical operation counter - MOC
NOTE: for full details on Emax 2 electrical and mechanical accessories see chapter “ Electrical
accessories
” starting on page 192.
Electronic accessories
Electronic accessories
Measurement Module - Protection and measurements of voltage, power and energy
Ekip Signalling 10K/ 4K/ 2K/ 3T/ Modbus TCP - Programmable input and output contacts
Ekip Supply - Power supply for trip units and modules
Ekip COM - Communication with multiple protocols
Ekip Synchrochek - Synchronism between two power supply sources
Ekip Multimeter - Power supply and measurements from switchgear front
Ekip LCD - Interface with LCD display for particular environmental conditions
NOTE: for full details on Emax 2 electronic accessories see chapter “ Accessories ” starting
on page
176.