ABB SACE Emax E4.2 - Menu

ABB | SACE Emax 2
Ekip Touch - Interface and menus
4 - Menu
46 | © 2023 ABB | 1SDH001330R1002 - ECN000297030
4 - Menu
Introduction
Press Enter or ESC from the main page to access the different menus of the Trip unit.
The menus are the 4th level pages that can be displayed and comprise list of:
• submenus
• settable parameters
• information and measurements
• commands that can be executed
Selection of each menu item enables: access to submenus, consultation of information in detail,
configuration of a parameter, execution of a command.
Elements of each item
The items in each list consist of:
• main name (white color)
• additional description or set value (light blue color)
Figure 17
Protections Menu
The Protections menu can be used to configure the following protections
(1)
:
Name Parameters SW package Page
L List and description in dedicated chapter
Standard
Protections
56
S List and description in dedicated chapter 57
S2 List and description in dedicated chapter 58
I List and description in dedicated chapter 59
G
(2)
List and description in dedicated chapter 60
Gext
(2)
List and description in dedicated chapter
(3)
87
MDGF
(2)
List and description in dedicated chapter
(4)
88
(1)
if the Adaptive Protections package is available and Dual set has been activated, an
intermediate menu where the set can be selected (Set A / Set B) will be available before the list of
protections
(2)
available for LSIG versions
(3)
available if the presence of toroid S.G.R. has been activated previously
(4)
available if the presence of the MDGF toroid has been previously activated