ABB SACE Emax E4.2 - Page 50

ABB | SACE Emax 2
Ekip Touch - Interface and menus
4 - Menu
47 | © 2023 ABB | 1SDH001330R1002 - ECN000297030
Advanced menus
The Advanced menu can be used to configure the following protections
(1)
:
Name Parameters SW package Page
MCR List in dedicated chapter
Standard
Protections
61
2I List in dedicated chapter 62
IU List in dedicated chapter 63
UV
(2)
List in dedicated chapter
Voltage
protections
65
OV
(2)
List in dedicated chapter 66
UV2
(2)
List in dedicated chapter 66
OV2
(2)
List in dedicated chapter 67
VU
(2)
List in dedicated chapter 67
S(V)
(2)
List in dedicated chapter
Voltage Advanced
protections
68
S2(V)
(2)
List in dedicated chapter 69
RV
(2)
List in dedicated chapter 71
UF
(2)
List in dedicated chapter
Frequency
protections
72
OF
(2)
List in dedicated chapter 73
UF2
(2)
List in dedicated chapter 73
OF2
(2)
List in dedicated chapter 74
RP
(2)
List in dedicated chapter
Power protections
75
D
(2)
List in dedicated chapter 76
RQ
(2)
List in dedicated chapter 79
OQ
(2)
List in dedicated chapter 78
UP
(2)
List in dedicated chapter 79
OP
(2)
List in dedicated chapter 78
ROCOF
(2)
List in dedicated chapter
ROCOF
protections
81
V DIR, VINV
(2)
List in dedicated chapter
Interface
protections (IPS)
145
59 S1
(2)
List in dedicated chapter 145
Warnings
VS Warning, FS Warning, FW1 Warning 145
Signallings
Threshold 1 I1, Threshold 2 I1,
Threshold Iw1, Threshold Iw2, Phase
Sequence
(2)
, Cosφ
(3)
Standard
Protections
95
Functions
External Trip, Trip Reset, Switch On
SET B
(4)
95
Synchrocheck List in dedicated chapter
(5)
92
RC List in dedicated chapter
(6)
90
(1)
if the Adaptive Protections package is available and Dual set has been activated, an
intermediate menu where the set can be selected (Set A / Set B) will be available before the list of
protections The only menu always present via Advanced is Functions
(2)
available if provided for by Trip unit model or if the relative SW package has been activated, where
possible (page 17)
(3)
CosΦ available if provided for by Trip unit model or if the Power Protections package has been
activated
(4)
SET B available when Adaptive Protections package is present
(5)
available when Ekip Synchrocheck is present
(6)
available when Rating Plug type Rc is installed in unit and when presence of toroid Rc has been
previously activated in Settings menu