ABB SACE Emax E4.2 - Page 190

ABB | SACE Emax 2
Mechanical accessories
2 - Mechanical safety accessories
187 | © 2023 ABB | 1SDH001330R1002 - ECN000297030
PLP: padlock in connected/
test/disconnected positions
The PLP locks the moving part of a withdrawable circuit-breaker in the fixed part, in one of the following
positions:
• connected
• test
• disconnected
Only one type is available that allows you to mount up to three padlocks with a diameter of 8 mm.
NOTE: the PLP lock can also be supplied in the presence of a KLP lock.
PLP for E1.2 PLP for E2.2 - E4.2 - E6.2
Information on the assembly is available on the website http://www.abb.com/abblibrary/
DownloadCenter/, in particular for E1.2 in the kit sheet 1SDH000999r0707 and for E2.2-E4.2-E6.2 in the
kit sheet 1SDH001000r0707.
KLP: key lock for connected/
test/disconnected positions
The KLP lock for connected/test/disconnected position locks the moving part of a withdrawable circuit-
breaker in the fixed part, in one of the following positions:
• connected
• test
• disconnected
NOTE: it is possible to lock the moving part in the disconnected position only by using the
additional accessory KLP lock.
The KLP lock for connected/test/disconnected positions is available with two types of lock:
• lock with different key code numbers (for a single circuit-breaker)
• lock with the same key code number (for more than one circuit-breaker). The maximum number
of key code numbers available is five.
Through an appropriate setup, the KLP lock for connected/test/disconnected positions can work with
three other types of lock:
• Ronis
• Profalux
• Kirk
• Castell
The maximum number of locks that can be installed per circuit-breaker is the two, for all types of lock.
NOTE: the supply of Ronis - Profalux - Kirk locks is at customer's expense.
NOTE: the KLP lock can also be supplied in the presence of a PLP lock.
KLP for E1.2 KLP for E2.2 - E4.2 - E6.2
Information on the assembly is available on the website http://www.abb.com/abblibrary/
DownloadCenter/, in particular for E1.2 in the kit sheets
• 1SDH000999r0704 and 1SDH000999r0726 for key locks with lock supplied by ABB
• 1SDH000999r0705 for the key locks with pre-engineering for Ronis - Profalux - Kirk locks
• 1SDH000999r0719 for the key locks with pre-engineering for Castell locks
and for E2.2-E4.2-E6.2 in the kit sheets:
• 1SDH001000r0704 for key locks with lock supplied by ABB
• 1SDH001000r0705 for the key locks with pre-engineering for Ronis - Profalux - Kirk locks
• 1SDH001000r0719 for the key locks with pre-engineering for Castell locks