ABB SACE Emax E4.2 - Page 47

ABB | SACE Emax 2
Ekip Touch - Interface and menus
3 - Graphic pages
44 | © 2023 ABB | 1SDH001330R1002 - ECN000297030
Measurements
Figure 14
If provided for by Trip unit model, the Measurements pages contain a list of measurements acquired in
real time, expressed in absolute value:
Page Name Measurements
1 Current Currents: phase, earth fault, external earth fault/Rc
2 Voltage Voltages: line-to-line, phase, neutral
3 Active power Phase and total active powers
4 Reactive power Phase and total reactive powers
5 Apparent power Phase and total apparent powers
6 Energy counters Total active, reactive and apparent energies
7 Power Controller Power Controller measurement summary, if installed
8 Load shedding Summary of Load Shedding measurements, if present
9 Ekip Signalling 3T
Summary of
Ekip Signalling 3T module measurements, if
installed
Ekip Touch configuration involves certain exceptions:
• the Ne current measurements are available with 4P and 3P + N configurations
• the phase voltage measurements are available with the 4P and 3P + active external neutral voltage
configuration
• with the 3P configuration, pages:
Active Power, Reactive Power and Apparent Power are replaced
by the
Powers page with the total active, reactive and apparent power measurements
• Ige/Rc current available with external toroid activated
•
Power Controller page available with Power Controller function activated
•
Load Shedding available with Load Shedding function activated
Press the sides of the display to browse the pages; press the HOME key to quit.
NOTE: each page can be set as the main page by pressing HOME , holding it for five seconds
and confirming the message on the display