ABB XFC G5 - Pipe Mount Installation

14 | XSERIES G5 START UP GUIDE | 2106001MNAA
Pipe mount installation
IMPORTANT NOTE:
Select a mounting location that allows for
easy access, is close to the tap valves, and complies with all
local and national codes.
Materials:
 One (1) enclosure mounting kit (includes instructions, brackets, U-bolts
and fastening hardware)
 One (1) pipe saddle with mounting hardware (size determined by
technician)
 One (1) 2 inch x 40 inch pipe (length may be extended if mounting a
solar panel). See Figure 3-1: Solar panel
.
Pipe-mount the XFC (XRC is similar):
1. Position the pipe saddle on the meter run and temporarily attach the
saddle to the meter run pipe using the associated hardware.
Figure 2-1: Mounting pipe
Legend: Mounting pipe
1
Meter run
3
Saddle
2
2 inch x 40 inch Mounting pipe
4
U Mounting bolt
2. Screw the mounting pipe into the saddle until it is tight.
2
1
4
3