ABB XFC G5 - 11 Configure Basic Security (Recommended)

68 | XSERIES G5 START UP GUIDE | 2106001MNAA
11 Configure basic security (recommended)
This procedure configures activates secured access to the XFC or XRC by
changing the default (OFF) position of the onboard security switch and
configuring the bi-level security codes.
IMPORTANT NOTE: After this procedure is completed,
connection to the XFC or XRC is restricted to users with the
correct security codes. This procedure requires opening the
enclosure to access to the XFC or XRC board.
Configure the security settings:
1. Open the XFC or XRC enclosure door and locate the onboard security
switch (S1). See the figure below.
Figure 11-1: S1 Security switch
Legend – S1 Security switch
1
Battery
2
Security switch
2. Ensure the security switch is set to OFF.
3. On the Station Setup tab, verify that the Security Switch Status field
shows off.
2
1