2106001MNAA | XSERIES G5 START UP GUIDE | 69
Figure 11-2: Station Setup tab – Security switch status
4. Type a four digit security code for Security Code Level 1 (read only
access).
5. Type a four digit security code for Security Code Level 2 (read and
write access).
Record the security codes. Once saved, they are
not visible on the Station Setup tab.
6. Click Send.
7. On the board, set the XFC or XRC security switch to ON.
8. On the Station Setup tab, click Re-read and check that the security
switch status is On. Enforcement of the security codes is in effect.
The codes will be required the next time PCCU32
attempts to connect to the
device.
To Next Page
Loading...
