74 | XSERIES G5 START UP GUIDE | 2106001MNAA
readings exceed the maximum counts or are less than the
minimum counts
1
A number represents the Display Group number currently
displayed.
↑
The displayed item’s value is above the Data High Limit value
on the display Item Setup screen.
↓
The displayed item’s value is below the Data Low Limit value
specified on the display Item Setup screen.
The status and alarm code area is
customizable. Each of the 8 annunciator display fields, shown in
Figure 13
-1: XSeriesG5 annunciators, may be programmed to
display any of the available indicators in
any of the 8 locations.
Failure to start
The LCD displays the startup sequence after power up. See details in
section 6.1 Super capacitor charging at boot time
. The display should begin
cycling though the pre-programmed items. If it fails to cycle and locks up,
follow the procedure below.
IMPORTANT NOTE: Display time for screens 1 through 4 will vary. If
the startup cycle stops, record the details on the screen. Provide
screen details to technical support to help them resolve the issue.
The screen has locked up
Follow this procedure to correct the problem:
1. Attach the lithium battery to the board.
2. Perform a warm boot:
a. Locate RESET (XFC S2 and XRC S6) on the electronic board,
press and hold for 10 seconds.
b. View the screen during startup to verify that the unit warm-
starts and begins cycling.
i. If the display moves through the startup screens and begins
cycling correctly, the reset was successful and it is not
necessary to continue this procedure.
ii. If the display does not begin cycling correctly or locks up on
one of the startup screens, continue to step 3.
3. Perform a cold boot:
To Next Page
Loading...
