62 | XSERIES G5 START UP GUIDE | 2106001MNAA
enabling Wi-Fi, the factory default parameters offer the highest security
and number of users. Change the default configuration to meet field
security requirements.
This procedure enables Wi-Fi and changes the default security passcode
(recommended). For non-default configuration or additional details click
Help from the Wi-Fi tab screen.
IMPORTANT NOTE: An XFC or XRC enabled as a Wi-Fi Access Point
does not provide bridging or routing between the wireless (Wi-Fi)
and the wired (Ethernet) networks.
Enable as a Wi-Fi Access Point:
1. Install the antenna. See 2.10 Install antenna
.
2. Configure the Network ID.
3. On the PCCU Entry mode navigation tree, select Communications.
4. Select the Wi-Fi tab.
Figure 10-7: Wi-Fi tab screen
5. Select the Enable Wi-Fi Access Point checkbox.
6. Change the default security passcode by clicking Change.
7. At the dialog box, type the factory default passcode: totalflow. Type
and confirm a new passcode, and click OK. Take note of the new
To Next Page
Loading...
