What You See on the Display What You Do Comments
3-5
Questions? Refer to Page 10-10 for Technical Support Instructions.
12. If required, scan or manually enter the
comment code and press Enter.
If there is no prompt to enter a
comment code, skip down to step 13.
The monitor may be enabled to scan or
enter a 1- to 2-digit comment code.
If prompted, scan or manually enter the
free text information and press Enter.
If there is no prompt to enter free text,
skip down to step 13.
The monitor may be enabled to scan or
enter the free text information. Up to two
free text fields may appear.
105 mg/dL
105 mg/dL
9. With the contact bars facing up, insert the
test strip into the test strip port until
it stops and Strip Inserted is displayed.
Prior to inserting the test strip, ensure that
the port protector is installed and that it
is clean and dry. Replace if necessary. The
display will alternate between Insert Strip
and Glucose.
10. Apply a drop of blood from the patient’s
finger, transfer pipette or syringe to the
target area of the test strip.
When sufficient sample has been applied,
the monitor beeps, displays Sample
Accepted and automatically starts the test.
For a detailed description of the test strip
target area, refer to the Test Strips section of
Chapter 1.
11. Wait for the monitor to analyze the
sample and display the test result.
The monitor counts down then displays
the test result. If an error is detected during
the assay, the assay is terminated and no
result is displayed. Once the assay begins,
all key presses are ignored until the assay is
completed.
Chapter 3: Patient Test
To Next Page
Loading...
Need help?
General
