8-9
Questions? Refer to Page 10-10 for Technical Support Instructions.
1. Press 1 for Test Setup.
2. P r e s s 5 for Security to continue to the
Security Glucose QC Interval screen.
3. If Ketone testing is enabled, press 1-Next
to continue to the Security Ketone QC
Interval screen, otherwise, press 1-Next
to skip down to step 5.
4. P r e s s 1-Next to continue to the
Security Operator ID Not Certified
screen.
5. P r e s s 1-Next to continue to the
Security Strip Lot Not on List screen.
6. P r e s s 1-Next to continue to the
Security Patient Data Not Confirmed
screen.
Chapter 8: Review Setup
What You See on the Display What You Do Comments
Review Test Setup for Security
Note: This section illustrates some representative settings.
If the monitor does not display these screens, please refer to Chapter 10, Troubleshooting.
To Next Page
Loading...
