8-6
Questions? Refer to Page 10-10 for Technical Support Instructions.
1. Press 1 for Test Setup.
2. Press 3 for Patient Test to continue to
the Patient Test Patient ID screen.
3. P r e s s 1-Next to continue to the Patient
Test Patient ID Truncation screen.
4. P r e s s 1-Next to continue to the Patient
Test Comment Code If In-Range
screen.
5. P r e s s 1-Next to continue to the Patient
Test Comment Code If Out-of-Range
screen.
6. P r e s s 1-Next to continue to the Patient
Test Patient ID Prompt screen.
7. P r e s s 1-Next to continue to the Patient
Test Repeat Manual ID Entry screen.
8. P r e s s 1-Next to return to the Test Setup
menu.
Chapter 8: Review Setup
What You See on the Display What You Do Comments
Review Test Setup for Patient Test
Note: This section illustrates some representative settings.
If the monitor does not display these screens, please refer to Chapter 10, Troubleshooting.
To Next Page
Loading...
