8-3
Questions? Refer to Page 10-10 for Technical Support Instructions.
1. P r e s s On/Off to turn on the monitor.
The Abbott logo screen will appear in black
for a few seconds and then will appear in
gray to ensure that the display is functioning
properly. Next the software version will
briefly appear.
2. Press the Menu button. The monitor starts in Test Mode. The
Menu button will toggle the monitor to
Menu Mode.
3. P r e s s 2 to select Review Setup.
Chapter 8: Review Setup
What You See on the Display What You Do Comments
Review Setup
Note: This section illustrates some representative settings.
If the monitor does not display these screens, please refer to Chapter 10, Troubleshooting.
To Next Page
Loading...
