Display of the resolution of the current stream
Display of the current connection status
Direct:
The Peer2Peer server was able to establish a direct connection between your
terminal and the camera.
Relay server*:
The Peer2Peer server could not establish a direct connection. The video data
is stored on the relay server for a short time so that your end device can obtain
the data from the server. This causes a delay of the stream.
Display of the current assessment of the connection
This represents the connection between the base station and the router.
Display of the currently consumed kilobit per second
Note
If the connection to your camera is always made via the relay server, please check the
following settings:
• Check if UPnP is enabled in your router
• Check if a hardware firewall or a software firewall denies a direct connection
• Check whether multiple "hops" (routers) are installed between the terminal device
and the Internet.
To Next Page
Loading...
Need help?
General
