2.2. Flap positions
The camera basically consists of two parts:
the camera housing made of plastic, and a cover/flap in fabric optics.
The flap is magnetically attached to the camera housing and is completely removable if required.
Through the flap and its integrated magnets, you control the privacy mode of the camera.
Flap is completely closed; the front of the camera is
completely covered by the flap:
The camera is in stand-by mode = privacy mode. No
sound recording, no image recording, no access via app
possible. From a technical point of view, no Peer2Peer
connection is possible.
To note: The camera will not switch to privacy mode until
the flap is completely closed and in contact with the
camera body with its integrated magnets.
Flap is completely open on half side; the camera lens can
be seen: The camera is active. The live image, the
memory, all functions and settings are accessed via app.
Flap is completely removed,
the complete front of the camera can be seen:
The camera is active. Access to the live image, memory,
all functions and settings are via app.
ATTENTION!
The flap must be open for the camera to be put into operation!
Please note:
When motion detection is active, a recording is started when the flap is closed; this is used
to verify who has set the camera to private mode.
If you do not wish to record, the camera must be deactivated before closing the flap.
To Next Page
Loading...
Need help?
General
