Abus TVVR36000 - Page 91

Configuration
91
NTP
Note
The recorder can synchronise the time with an ex-
ternal server. Several server addresses are avail-
able on the Internet for this purpose.
1.
Tick the “Enable NTP” box and then enter the inter-
val at which the synchronisation should be made
again. Enter the IP address of the NTP server and
the NTP port.
2.
Confirm the settings by pressing Apply.
Email
In the event of an alarm, the device can send a message
by e-mail. Enter the e-mail configuration here:
Parameter
Setting
Enable Server
Authentica...
Tick the box when authentication is
made on the server of the Internet
provider
User Name
E-mail account at the provider
Password
Password connected to the e-mail
account
SMTP Server
SMTP server address of the provider
SMTP Port
Enter the SMTP port here
(Default: 25)
Enable SSL
Tick the box to activate the e-mail
encryption
Sender
Name of the sender
Sender´s
Adresse
Corresponding e-mail address for
the e-mail account
Sender´s Recei-
ver
Select three possible recipients for
the e-mail
Receiver
Enter the name of the recipient here
Receiver´s Ad-
resse
Enter the e-mail address of the
recipient here
Attach picture
Tick the box when camera images
should also be sent with the email as
photo files
Interval
Select a triggering time between 2
and 5 seconds. The images are only
sent if motion was detected during
the defined time.
1.
Enter the parameters of the e-mail notification.
2.
Click on Test to send a test e-mail.
3. Please clarify if your settings are correct and you
have received a confirmation mail. Then click on
Apply.
Note
The device sends an e-mail to the specified recip-
ients.
If the e-mail is not received, check the settings
and correct them.
If necessary, check the spam filter of your e-mail
client.
Note
You obtain the access data and settings for send-
ing SMTP from your email provider. Some email
providers only provide SSL encryption for sending
emails. This recorder was tested for SSL compati-
bility with the following providers: GMX, Web.de,
Gmail.