ACADEMY LCFF 1.2 - Calibration Step 2 - Head Tube Centre Line & Roll

LCFF 1.2 Setup & Calibraon
workshop manual v2
Page 15
© The Bicycle Academy Limited 2019
Adjustment screws
Adjustment screws
Clamping bolts
Clamping bolts
Calibraon Step 2 - Head Tube Centre Line & Roll
Set the xture head tube X, Y and angle for the
planned frame build.
Insert the laser calibraon tool as shown and ensure it
is referencing the head tube plate correctly.
Having calibrated the laser pointer (see page 11) aim
the laser at the lowest point on the calibraon tool
and secure the laser holder with a nut.
Slacken the 4x M5 clamping bolts to allow the head
tube plate to slide and align the centre line of the cali-
braon tool with the laser dot.
Aim the laser at the top of the calibraon tool and
secure the laser holder with the nut again.
Evenly adjust the grub screws on one side to align the
calibraon tool centre line with the laser dot.
Take care to adjust both grub screws (see page 13).
Aim the laser at the base of the tool again, secure and
slide the head tube plate if required. Tighten the 4x
clamping bolts evenly - DO NOT OVER TIGHTEN.
Repeat the process unl you are sased that the laser
strikes the calibraon tool centre line in both posions
shown with the 4x clamping bolts ghtened -
DO NOT OVER TIGHTEN.
1.
2.
3.
4.
5.
6.
7.
8.