Access Sensor Technologies UPAS User Guide 51
Table 7 A Description of Log File Setup Summary Parameters
Parameter Description
UPASserial UPAS serial identification-numerical
UPASfirmware Current version of firmware running on the UPAS
LifetimeSampleCount Number of samples started in the lifetime of the UPAS
LifetimeSampleRuntime Number of cumulative sample hours in the lifetime of the UPAS
Sample Identification
UPASlogFilename Name of the file as saved on the SD card
SampleName Sample name as entered in the App
CartridgeID Cartridge ID as entered in the App
Setup Summary
GPSUTCOffset UTC offset for local time zone
StartOnNextPowerUp Programming the UPAS to start on next power-on (0=no 1=yes)
ProgrammedStartDelay Programmed delay between App start and UPAS program run (in seconds)
ProgrammedRuntime Programmed run time (in seconds) (360000000 means 'indefinite')
VolumetricFlowRate Programmed volumetric flow rate (L*min^-1)
FlowOffset Flow offset as entered in the App (as a %)
DutyCycle Programmed duty cycle (as a %)
DutyCycleWindow Period of duty cycle (in seconds)
GPSEnabled
GPS status during the programmed run is indicated by the listed outputs
0 = the GPS was disabled during the sample
1 = the GPS was enabled during the sample
LogFileMode
Type of log being recorded is indicated by the listed outputs.
0 = data was logged normally every 30 seconds
1 = data was logged every second in debug mode
LogInterval Interval between logged data points during sampling (in seconds)
AppLock
Status of App Lock
0 = the settings are unlocked and can be modified in the App
1 = the settings are locked and cannot be changed until unlocked
-1 = The App Lock is not set
AppVersion Current App version used to program the UPAS (i=iOS, A=Android)
Sample Summary
StartDateTimeUTC
UTC Date/Time when sample started (YYYY-MM-DDTHH:MM:SS) (UTC date time
format)
StartDateTimeLocal
Local Date/Time when sample started (YYYY-MM-DDTHH:MM:SS) (Local date time
format)
StartBatteryCharge Battery SOC % when sample started (%)
To Next Page
Loading...