Access VIRUS CLASSIC - Output Select; Part Enable; MIDI Channel

104
If the selected output is monophonic, then the Panorama settings and modulations in the sound
program are inactive.
OUTPUT SELECT
When you select an internal aux path as a signal output, you of course must route the signal of
another PART to this aux path via INPUT SELECT before you can establish a signal connection
between the two PARTS. Several PARTs can simultaneously access the external input or the internal
aux paths via OUTPUT SELECT.
In SINGLE MODE, OUTPUT SELECT does not appear in the menu; in this case Output 1 (stereo) is
preset.
PART ENABLE
Switches the MIDI receive mode of a given PART ON and OFF, i.e. enables reception of MIDI data.
MIDI CHANNEL
elects the MIDI channel of the PART. If two or more PARTs are selected for the same MIDI channel,
these PARTs will be played simultaneously. This creates what are generally called layer sounds.
OUT 2 R
The right jack of dual Output 2 (mono)
OUT 3 L
The left jack of dual Output 3 (mono)
OUT 3 L+R
Both jacks of dual Output 3 (stereo)
OUT 3 R
The right jack of dual Output 3 (mono)
AUX 1 L
The left channel of internal Aux 1 (mono)
AUX 1 L+R
Both channels of internal Aux 1 (stereo)
AUX 1 R
The right channel of internal Aux 1 (mono)
AUX 2 L
The left channel of internal Aux 2 (mono)
AUX 2 L+R
Both channels of internal Aux 2 (stereo)
AUX 2 R
The right channel of internal Aux 2 (mono)