VIRUS CLASSIC MANUAL 371
Appendix
All bytes are shown in decimal representation.
Classes
P: PERFORMANCE CONTROLLER
Accessible by Control message. Performance Controllers are not stored with a Single-Sound. If
more than one Multi Part is set to the same MIDI channel, all Parts on this MIDI channel receive the
same Performance Controllers.
A: SOUND PARAMETER OF BANK A
Accessible by Control message, SysEx-Parameterchange and Single-Dump.The Sound Parameters
are stored with a Single Sound. When received as Control Message, the Sound Parameter is
received only by the Multi Part with the lowest part number, if more than one Multi Part is set to the
same MIDI channel. When received as SysEx-Parameterchange or Single-Dump, the part is
addressed by the part number irrespective of the actual MIDI channel setting.
Part State Bitfield:
Bit 0 Part Enable 0:Off 1:On
Bit 1 Part Midi Volume
Enable
0:Off 1:On
Bit 2 Part Hold Pedal Enable 0:Off 1:On
Bit 3 Keyb To Midi 0:Off 1:On
Bit 4 Internal
Bit 5 Note Steal Priority 0:Low 1:High
Bit 6 Part Prog Change
Enable
0:Off 1:On
NO REF NAME RANGE VALUE TEXT
To Next Page
Loading...
