372
B: SOUND PARAMETER OF BANK B
Accessible by MIDI Polyphonic Pressure, SysEx-Parameterchange and Single-Dump.The Sound
Parameters are stored with a Single Sound. When received as Polyphonic Pressure, the Sound
Parameter is received only by the Multi Part with the lowest part number, if more than one Multi Part
is set to the same MIDI channel. When received as SysEx-Parameterchange or Single-Dump, the
part is addressed by the part number irrespective of the actual MIDI channel setting.
M: MULTI PARAMETER
Accessible by SysEx-Parameterchange and Multi-Dump The Multi Parameters are stored with a
Multi Patch.
MS: MULTI/SINGLE PARAMETER
When in Single Mode, the parameter is received and stored with the Single Sound.When in Multi
Mode, the parameter is received and stored with the Multi Patch. In Multi Mode the Single Sound
settings are ignored while the corresponding Multi Patch settings are active.
NP: NON-PART-SENSITIVE SOUND PARAMETER
When in Multi Mode, the parameter affects all Multi Parts.
BPC: BANK/PROGRAM-CHANGE PARAMETER BANK SELECT
selects the Single bank accessed by a subsequent Program Change, similar to the regular Bank
Select.Bank Change directly changes the Single program to the requested bank, without changing
the program number. Program Change directly changes the Single program to the requested pro-
gram number, without changing the bank number; similar to the regular Program Change. Part
number $40 will address the Single buffer in Single Mode.
G: GLOBAL PARAMETER
The Global Parameters are independend of Single Sounds or Multi Patches and non-part sensitive.
To Next Page
Loading...
