VIRUS CLASSIC BEDIENUNGSANLEITUNG 345
Tipps Und Tricks
DIREKTES ÜBERSPIELEN DES BETRIEBSSYSTEMS
There’s no danger of a flawed MIDI transmission burning faulty software into the Virus’ memory.
When the device receives MIDI data, this information is first buffered in the delay memory of the
Virus, where it is checked for errors. If the device finds an error, the loading routine is aborted and it
will generate an error message. Then you can try repeating the process. The old operating system
will remain unharmed. Only when you actually initiate a burn operation will the old operating system
be deleted and overwritten with new data.
Das direkte Überspielen des Betriebsystems von einem Virus zu einem zweiten Virus
1 Verbinden Sie den sendenden Virus (Virus 1) über den MIDI-Out-Port mit dem empfangenden
Virus (Virus 2) am Midi-In-Port.
2 Schalten Sie den Virus 1 ein, während Sie die [Store]-Taste gedrückt halten. Das Display zeigt
dann SYSTEM UPDATE.
LOADING THE OPERATING SYSTEM FROM ONE VIRUS TO
ANOTHER
1 Connect the sending Virus’ (Virus 1) MIDI Out port to the receiving Virus’ (Virus 2) MIDI In port.
2 Switch on Virus 1 while you’re holding the [Store] button pressed. The display will read SYSTEM
UPDATE.
3 Drücken Sie anschließend die Tasten [Value +], [Store], [Store] hintereinander.
MENU POWER ON + STORE > SYSTEM UPDATE > RECEIVE
DISPLAY
01111111111111111112
SYSTEM UPDATE
[STORE] Receive≤
61111111111111111154
MENU POWER ON + STORE > SYSTEM UPDATE > RECEIVE
DISPLAY
01111111111111111112
SYSTEM UPDATE
[STORE] Receive≤
61111111111111111154
To Next Page
Loading...
