7-6 Facility Performance Testing User Manual
5. If Door Ajar is set in Event Preferences
to “Log and Status” or “Alarm”, verify
that the central computer correctly
logged this alarm and that any
networked computer also sees the alarm.
6. Record the results (pass or fail).
7. If the test fails to cause a Door Ajar
alarm:
a. Notify staff and security of the
vulnerable area.
b. Check for visible damage or
tampering to the zone equipment.
c. Have a maintenance technician
verify power to the zone equipment
d. Call your Accutech Representative.
8. To reset the zone, close the door
completely. Depending on settings, the
system may reset automatically or, if
necessary, enter a Keypad reset and
clear the alarm on the PC.
Loiter Test
This test will evaluate the Loiter feature
1. Notify staff and security that you will be
testing zone performance and alarms
will be generated. They should pay
special attention to traffic during this
time.
2. Using an S-TAD, activate the test Tag.
3. Enter a monitored zone and linger there.
NOTE: Be sure the door stays closed.
4. Depending upon the time delay settings,
the zone should register a Loiter alarm
after the predetermined time.
5. Verify and record the time setting.
6. If Loiter is set in Event Preferences to
“Log and Status” or “Alarm”, verify this
alarm is logged on the central computer
and any other remote computers
networked to it.
7. Record the results (pass or fail)
8. If the test fails to cause a Loiter alarm:
a. Notify staff and security of the
vulnerable area.
b. Check for visible damage or
tampering to the zone equipment.
c. Have a maintenance technician
verify power to the zone equipment
d. Call your Accutech Representative.
9. To reset the zone, deactivate the test Tag
and, if necessary, enter a Keypad reset
and clear the alarm on the PC.
10. Depending on settings, the system may
reset automatically or, if necessary,
enter a Keypad reset and clear the alarm
on the PC.
To Next Page
Loading...
