Accutech LC1400 User Manual

3-13Chapter 3: Tags, IDTAD, & TTS
Programming and
Conguration Modes
IDTAD Programming Mode
If you want to change and/or add user codes,
or if you want to add a certain function to the
IDTAD, you will need to enter programming
mode.
To Enter Programming Mode:
Press Enter>Enter>Master Code>Enter
(198237645 is the default master code).
To Exit Programming Mode
Press the Power/Clear button.
To prevent the screen from timing out and
turning off while configuring, press the
Enter button when the display indicates it
is counting down to Power OFF. The display
will indicate “20 seconds to power off”, then
“7 seconds to power off” before shutting
down.
Important
LC1400 System Tag Types
• LT Tag
• SB Tag
• WW Tag (Wander Wearable—Black)
BAT—Tag Battery Level
When tested while the tag is active, the tag
battery level will be displayed as "GOOD" (g)
if the battery level is adequate. Once a tag
falls below a predetermined level, the tag
will generate a low battery flag and display
LB (i). In this case, you must replace the tag
immediately. Never use a tag with a low
battery.
WAR—Tag Warranty Date
The tag warranty date will be displayed with
6 numbers. The first two numbers are the
month, the next two numbers are the day, and
the final two numbers are the year (MM/DD/
YY). This set of numbers will reflect the end
date of the tag's warranty, which is one year
from the start date of the tag's warranty.

Accutech LC1400 Specifications

General

Brand	Accutech
Model	LC1400
Category	Measuring Instruments
Language	English