79
BIOS utility
The BIOS utility is a hardware configuration program built into your
computer's Basic Input/Output System (BIOS). Since most computers are
already properly configured and optimized, there is no need to run this
utility. However, if you encounter configuration problems and get the
"Run Setup" message, you will need to run this utility.
Note: Before you run BIOS, make sure that you have saved all
open files. The computer reboots immediately after you exit
Setup.
To run the BIOS utility, press the key combination Ctrl+Alt+Esc. For
information about BIOS and how to configure your computer, refer to
the Veriton 3200 online manual (see “Accessing the online manual” on
page 6).
ver3200AAC-0.book Page 79 Friday, March 2, 2001 3:52 PM
To Next Page
Loading...
