Altos R520 Installation Configuration Guide 96
# cd /tmp/
# unzip ir3_Linux_RWC2_v2_19_01.zip
# chmod 755 install.sh
# chmod 755 RunRPM.sh
# ./install.sh
3. Type y to accept the license agreen and select 1 for full installation.
4. To start RAID Web Console 2 on, select applications -> System Tools ->
RAID Web Console 2 Startup UI
Red Hat Enterprise Linux 4.0 EM64T Update 3 Installation (with
integrated SAS hardware RAID)
Below information describes how to manually install Red Hat Enterprise Linux
4.0 EM64T Update 3 on Altos R520 with integrated SAS hardware RAID.
Drivers Required
For Red Hat Enterprise Linux 4.0 Update 3 Installation, the following device
drivers are required.
Device Version EasyBUILD Version
Integrated SAS
hardware RAID
00.00.03.03 EasyBUILD 7.1 build 400 (or later)
Onboard Chipset N/A OS built-in
Onboard Gigabit
Ethernet
7.0.38-NAPI EasyBUILD 7.1 build 400 (or later)
Onboard VGA N/A OS built-in
Onboard USB 2.0 N/A OS built-in
Software Required
The management utility of integrated SAS hardware RAID can be found in the
EasyBUILD.
Software Version EasyBUILD Version
RAID Web Console
2
1.13-07 EasyBUILD 7.1 build 400 (or later)
Configuring integrated SAS hardware RAID
Please refer to the Appendix A. for the integrated SAS hardware RAID
configuration.
Installation Tips
NOTE. There is no built-in driver Integrated SAS hardware RAID in the Red Hat
Enterprise Linux 4.0 EM64T Update2. You need an external USB floppy drive to
load driver during the OS installation.
To Next Page
Loading...
