43 Altos R520 Installation Configuration Guide
Configuring onboard SATA RAID
Please refer to the Appendix C. for the onboard SATA RAID configuration.
Installation Tips
NOTE. There is no built-in driver of Onboard SATA RAID in the Windows Server
2003 x64. You need an external USB floppy drive to load driver during the OS
installation.
1. As Windows Server 2003 x64 can’t recognize the onboard SATA RAID, you
need to make a driver diskette from the EasyBUILD first before the
installation.
2. Press F6 at the beginning of installation for providing the driver diskette
for the onboard SATA RAID.
3. Select “Intel Embedded Server RAID Technology II (Windows XP/2003 64-
bit)” as target driver
4. After loading the RAID driver from diskette, follow the normal procedure
to finish the installation.
Chipset Driver Installation
1. After the installation completes, you would see the following devices
with yellow mark in Device Manager.
2. Please insert the EasyBUILD into the optical drive
To Next Page
Loading...
