Acer Altos R520 - Initial RAID Volume; Save and Exit Embedded RAID II Configuration Utility

Altos R520 Installation Configuration Guide 166
34. Press Enter again to select array to configure.
35. Press spacebar to select the array and press <F10> to configure the logical
drive
36.
The default RAID level for 2 disk drives is RAID1. Just select Accept to use
the default setting and press <Enter> to return to the
ARRAY SELECTION
MENU.
37. Press <Enter> to end the array configuration.
38. Select YES to Save Configuration and press any key to return to the
Configure menu.
Initial RAID Volume
39. Press <Esc> to return to the Management Menu.
40. Select Initialize from Management menu. All logical drives should be
listed under Logical Drives.
41. Press <Spacebar> to select drives for initialization. The selected drive will
be shown in yellow.
42. After selecting the drives, press <F10> and select YES to start the
initialization process.
43. When initialization is complete, press any key to continue.
44. Press <Esc> to return to the Management Menu.
Save and Exit Embedded RAID II Configuration Utility
45. When RAID configuration and initialization is complete, press <Esc> in the
Management Menu and select YES to exit the Embedded RAID
Configuration Utility.
46. Press <Ctrl> + <Alt> + <Del> to reboot the server.