65 Altos R520 Installation Configuration Guide
Intel PROSet Utility 13.0.44.0 EasyBUILD 8.0 build 200 (or later)
Configuring integrated SAS hardware RAID 2
Please refer to the APPENDIX D. for the integrated SAS hardware RAID 2
configuration.
Installation Tips
NOTE. There is no built-in driver Integrated SAS hardware RAID 2 in the
Windows Server 2003. You need an external USB floppy drive to load driver
during the OS installation.
1. As Windows 2000 can’t recognize the integrated SAS hardware RAID 2,
you need to make a driver diskette from the EasyBUILD first before the
installation.
2. Press F6 at the start of installation to provide the driver disk for the
onboard ROMB.
3. Select “Intel(R) SAS RAID Controller Driver (Windows 2000)” as target
driver
4. After loading the driver from diskette, follow the normal procedure to
finish the installation.
Chipset Driver Installation
1. After the installation completes, you would see the following other
devices listed in Device Manager.
To Next Page
Loading...
