25 Altos R520 Installation Configuration Guide
Software Required
The management utility of integrated SAS SW RAID can be found in the
EasyBUILD.
Software Version EasyBUILD Version
RAID Web Console
2
2.63 EasyBUILD 8.0 build 200 (or later)
Intel PROSet Utility 13.0.44.0 EasyBUILD 8.0 build 200 (or later)
Configuring integrated SAS SW RAID
Please refer to the Appendix B. for the integrated SAS SW RAID configuration.
Installation Tips
NOTE. There is no built-in driver of Integrated SAS SW RAID in the Windows
Server 2008 x64. You need an external USB floppy drive or USB Flash drive to
load driver during the OS installation.
1. Please make a driver diskette from the EasyBUILD first before the
installation.
2. Click on “Load Driver” when “Where do you want to install Windows”
message displayed.
3. Select “Intel Embedded Server RAID Technology II (A:\MegaSR.inf)” as
target driver
4. After loading the RAID driver from diskette, you could click “Drive
options” to partition the drive.
5. Follow the normal procedure to finish the installation.
6. After the installation completes, you would see the following devices
with yellow mark in Device Manager.
To Next Page
Loading...
