3-20 Machine Maintenance Procedures
4. Disconnect LVDS cable from mainboard connector (F) (Figure 3-15).
5. Disconnect DC-in cable from mainboard connector (G). Remove the tape (H) securing
DC-in cable on the mainboard and remove the cable from the cable guide.
(Figure 3-15).
6. Disconnect Power Switch board cable (I), Speaker cable (J) and Touchpad cable (K)
from mainboard connector (Figure 3-16).
Figure 3-16. Mainboard Connector Location
7. Remove two (2) screws (E) securing the mainboard in place (Figure 3-15).
8. Remove Mainboard by lifting it from the base assembly.
Make sure all cables are moved away from the device to avoid damage
during removal.
To Next Page
Loading...
