Machine Maintenance Procedures 3-47
3. Starting from the top, remove the clear mylar tape (C) and disconnect the LVDS cable
from the LCD panel connector (D) (Figure 3-47)
.
Figure 3-47. LVDS Cable
LVDS Cable Installation 0
1. Place LVDS cable into the LCD panel connector (D) and secure clear mylar tape (C)
(Figure 3-47).
2. Adhere the yellow tape (B) to the LVDS cable connector to secure it. Refer to
Figure 3-46.
3. Place LVDS cable (A) on the rear of the LCD panel. Refer to Figure 3-45.
4. Install LCD panel.
To Next Page
Loading...
