Acer Aspire T310 - Page 46

Chapter 2 33
The following table describes each parameter under the sub-menu. Settings in boldface are the default and
suggested values.
Parameter Description Options
IRQ [3-7, 9-15], NMI This option determines whether any activity for
IRQ 3-7/9-15 will cause the system to wake from
a power saving mode.
Enabled
Disabled
IRQ 8 Break Suspend Determines whether the system will monitor IRQ
8 activity and wake the system from a power
saving mode when IRQ 8 is activated.
Enabled
Disabled
Power On by Ring An input signal on the serial Ring Indicator (RI)
line (in other words, an incoming call on the
modem) awakens the system from a soft off
state.
Enabled
Disabled
Wake-Up by PCI Card This item specifies whether the system will be
awakened from power saving modes when
activity or input signal of the specified hardware
peripheral or component is detected.
Enabled
Disabled
USB Port Wakeup from S3 This option allows you to specify whether the
system will be awakened from power saving
modes when activity or input signal of the
specified hardware peripheral or component is
detected.
Enabled
Disabled
PS2KB Wakeup from S3 This option allows you to set hot key combination
to turn on the system by keyboard.
Hot Key
PS2MS Wakeup from S3 This option allows you to set the mouse action to
turn on the system.
Enabled
Disabled
Resume by Alarm When set to Enabled, the following three fields
become available: Month Alarm, Day of Month
Alarm, and Time Alarm Upon arrival of the alarm
time, it will instruct the system to wake up.
Enabled
Disabled