Chapter 2 43
Security Menu
NOTE: Refer to “Remove HDD/BIOS Password” section if you need to know how to remove HDD/BIOS
Password.
Parameter Description Option
Supervisor Password Is Indicates whether a supervisor password has been
assigned.
Clear or Set
User Password Is Indicates whether a user password has been
assigned.
Clear or Set
Secondary MAS.Disk Status Indicates whether a hard disc drive password has
been assigned.
Clear or HDD Password Set
Set Supervisor Password Press Enter to configure the supervisor password.
Set User Password Press Enter to configure the user password.
Set Secondary MAS.Disk
Password
Press Enter to configure the hard disc drive
password.
Password on Boot Enables or disables security check during POST.
Disabled or Enabled
Phoenix TrustedCore(tm) Setup Utility
Main
Item Specific Help
Supervisor Password
controls access of the
whole setup utility.
Itcanbeusedtoboot
up when Password on
boot is enabled.
Supervisor Password Is:
User Password Is:
Secondary MAS.Disk Status:
Set User Password
Set Secondary MAS.Disk Password
Password on Boot:
Set Supervisor Password
F1
Esc
Help
Exit
Select Item
Select Menu
Change Values
Select Sub-Menu
-/+
Enter
F9
F10
Setup Defaults
Save and Exit
Information Advanced Security Boot Exit
Clear
Clear
Clear
[Enter]
[Enter]
[Disabled]
[]Enter
SG_TM4720_4320_Book.book Page 43 Friday, April 20, 2007 11:14 AM
To Next Page
Loading...
