Chapter 3 85
13. Turn the inverter board over.
14. Disconnect the inverter board cable from its connector, then disconnect the 2P cable on the inverter
board.
15. Remove the inverter board.
Removing the LCD with Brackets
1. See “Removing the Battery Pack” on page 51.
2. See “Removing the SD Dummy Card” on page 51.
3. See “Removing the Express Dummy Card” on page 52.
4. See “Removing the Lower Cover” on page 53.
5. See “Removing the Fan Module” on page 60.
6. See “Removing the CPU Heatsink Module” on page 61.
7. See “Removing the CPU” on page 62.
8. See “Removing the Middle Cover” on page 63.
9. See “Removing the Keyboard” on page 64.
10. See “Removing the LCD Module” on page 67.
11. See “Removing the LCD Bezel” on page 83.
SG_TM4720_4320_Book.book Page 85 Friday, April 20, 2007 11:14 AM
To Next Page
Loading...
