Transmitting data while making measurements
Connect the sound-level meter and the PC
>>Settings on the PC side
(The settings are the same as when transmitting data after measurements)
>>Settings for and operation of the sound-level meter.
1)
<menu> Screen settings
Interval Off
I/O Off
baud rate 9600
Note: Make settings for other items as needed to suit your purpose in making measurements
.
2) Press Set to confirm, then press View, and the measurements screen appears.
Latest numerical data received is displayed here.
Press Menu
74.6
00h 000h00m00s
FAST
LA
20 100
Manu
3) If Start/Stop is pressed, at the same time
measurements begin and data is
transmitted for each measurement
interval. The data is appended to data
displayed on the PC screen.
4) If Start/Stop is pressed during
measurements,both measurements and
transmission stop.
Note: Transmitted data is not stored in the
memory of the sound-level meter.
After transmission be sure to save it on
the PC.
Meas Mode :Manu
Interval :Off
I/O :Off
Data delet :Off
LCD cont :****
date y/m/d :00/11/20
Range :100dB
Dyn charF :FAST
Freq corr :A
Meas time :***
View :L50
baud rate :9600
To Previous Page
