45
4.4.7 UPnP Configuration
The DSL device supports a control point for Universal Plug and Play (UPnP) version 1.0,
and supports two key features: NAT Traversal and Device Identification. This feature
requires one active WAN interface. In addition, the host should support this feature. In the
presence of multiple WAN interfaces, select an interface on which the incoming traffic is
present.
With NAT Traversal, when an UPnP command is received to open ports in NAT, the
application translates the request into system commands to open the ports in NAT and the
firewall. The interface to open the ports on is given to UPnP when it starts up and is part of
the configuration of the application.
For Device Identification, the application will send a description of the DSL device as a
control point back to the host making the request.
Fields in this page
Field Description
UPnP Daemon Enable/disable UPnP feature.
Binded WAN Interface Select WAN interface that will use UPnP from the drop-down lists.
Function buttons in this page:
Apply Changes
Click to save the setting to the system configuration.
To Next Page
Loading...
Need help?
General