57
receives the message, it sends messages in reply. To use it, you must know the IP
address of the host you are trying to communicate with and enter the IP address in the
Host Address field. Click Go! To start the ping command, the ping result will then be shown
in this page.
Fields in this page:
Field Description
Host Address The IP address you want to ping.
4.6.2 ATM Loopback
In order to isolate the ATM interface problems, you can use ATM OAM loopback cells to
verify connectivity between VP/VC endpoints, as well as segment endpoints within the
VP/VC. ATM uses F4 and F5 cell flows as follows:
− F4: used in VPs
− F5: used in VCs
An ATM connection consists of a group of points. This OAM implementation provides
management for the following points:
− Connection endpoint: the end of a VP/VC connection where the ATM cell are terminated
− Segment endpoint: the end of a connection segment
To Next Page
Loading...