Acteon Piezotome Cube - 11 Technical specifications of the medical device; 11.1 Identification; 11.2 Generator; 11.3 Length of cords

11 Technical specifications of the medical device
11.1 Identification
Manufacturer SATELEC, a company of Acteon group
Name of the medical device Piezotome Cube
11.2 Generator
Supply voltage 100 - 240 VAC
Power supply frequency 50 / 60 Hz
Power consumption 150 - 150 VA
Voltage supplied to handpiece 150VAC
Power setting range D1 - D4
Output frequency 28kHz - 36 kHz
Type of leakage currents BF
Operating mode Intermittent: 10 minutes ON / 5 minutes OFF
Electrical rating I
Fuse (mains connector) 2 fuses T2AL, 250 VAC
Width 251 mm
Height 160 mm, 481 mm with bracket
Depth 271 mm
Weight 3,500 g without accessories
Ingress protection rating IPX0
11.3 Length of cords
Handpiece cord 2 500 mm +/- 50 mm
Control pedal cord 2 500 mm +/- 50 mm
11.4 Irrigation
Bottles or irrigation bags should not weigh more than one kilogram. A heavier container will make the medical device
tip over.
Maximum volume of irrigation solution bags 1,000 ml
Maximum weight of irrigation solution bags 1,000 g
Nominal water output flow at the end of the
handpiece Cube LED
0 ml/min to 120 ml/min
Maximum water output flow at purge 120 ml/min
11.5 Footswitch
Width 173mm
Height 140mm including arch
Depth 176mm
Weight 1,060 g
Ingress protection rating IPX1
User Manual | Piezotome Cube | J50101 | V4 | (17) | 03/2018 | NO37EN010D - Page 29/39