SPM-32A ... SPM-36A 3.4 Default settings (reset)
3-13
3.4 Default settings (reset)
The instrument can be set to the default settings at any time
by pressing
simultaneously to perform a “hardware reset”.
The message “Default setting” appears during the self-test
and the stored instrument settings are retained.
Default settings:
– Selective level measurement
– Tuning frequency = 8 kHz.
– Bandwidth 3.1 kHz
– Output impedance = 75 Ω unbalanced (UNBAL).
ON/OFF CLEAR
To Next Page
Loading...
