ACTi A950 - Page 59

58
 Upload Image by FTP
Select this item and the administrator can assign an FTP site and
configure various parameters. When audio is detected, event images
will be uploaded to the appointed FTP site. Note that to implement this
function, one of the streaming MUST be set as MJPEG; otherwise, this
function will be grayed out and cannot be accessed.
<Pre-trigger buffer> function allows users to check what happened to
cause the trigger. The <Pre-trigger buffer> frame rate could be
pre-determined. On the other hand, <Post-trigger buffer> is for users to
upload certain amount of images after audio event occurs.
NOTE: <Pre-trigger buffer> generally ranges from 1 to 20 frames.
However, the range will change accordingly if the frame rate of
MJPEG on Streaming> Video Configuration is 6 or smaller.
Check the box <Continue image upload> to upload the triggered images
during certain time or keep uploading until the trigger is off.
Select <Upload for __sec> and enter the duration in the blank.
The images of the duration will be uploaded to FTP when the audio
event occurs. The setting range is from 1 to 99999 sec. Select <Upload
during the trigger active> to make the images keep being uploaded to
FTP during the trigger active until the event stops. Set the Image
frequency as the upload frame rate. The setting range is from 1 to 15
frames per second.
NOTE: Make sure FTP configuration has been completed. Refer
to section FTP for further details.
 Upload Image by E-Mail
Select this item and the administrator can assign an E-mail address and
configure various parameters. When audio is detected, event images
will be sent to the appointed E-mail address. Note that to implement this
function, one of the streaming MUST be set as MJPEG; otherwise, this
function will be grayed out and cannot be accessed.
<Pre-trigger buffer> function allows users to check what happened to
cause the trigger. The <Pre-trigger buffer> frame rate could be
pre-determined. On the other hand, <Post-trigger buffer> is for users to
upload certain amount of images after the audio event occurs.