ActionTec PK-5000 - Page 38

37
Chapter 5 Configuring Advanced Settings
4. Enable Public/Private IP !DDRESSING4HISFEATUREISUSEDINCONJUNCTIONWITH
-ULTIPLE3TATIC)0!DDRESSES7HENSELECTEDTHE'ATEWAYUSES.!4for private
IP addressing for the ,!., allowing both public and private IP addressing to be
configured to the ,!.simultaneously, while the $(#0server is reserved for
PRIVATE)0ADDRESSING!LLCOMPUTERSUSINGPUBLICIP addresses must have the
public IP addresses statically assigned.
5. Select the DNS type. If static DNS address was selected, enter the primary DNS
address and, optionally, the secondary DNS address in the appropriate text
boxes.
6. Select Dialout on-demand (optional). To have the Gateway automatically
connect to the Internet whenever needed (when a Web browser is opened,
FOREXAMPLEACTIVATEh$IALOUTONDEMANDvBYCLICKINGINTHEAPPROPRIATE
check box. When Dialout on-demand is activated, the user can also set the
Gateway to disconnect from the Internet after a certain amount of idle time
(no Internet activity). To do this, enter the number of idle time minutes
(minimum 2 minutes) before disconnection occurs in the text box before
h-INUTESv
7. !DJUSTMTU settings (optional). Enter the maximum transmission unit (MTU)
value (in bytes) in this text box. This value corresponds to the largest physical
packet size the network is allowed to transmit. Packets larger than this size are
divided into smaller packets. It is recommended to leave this value set at the
default (1492).
When finished in this screen, click Apply to activate any changes made.