AcuRite 01021 - Programmable Alarms

16
Programmable Weather Alarms
Each selectable weather category features an alarm option. When an alarm sounds,
the display emits audible beeping and ashes the affected category, its alarm
settings, and any other relevant data.
Alarms can be customized to alert you when your programmed value is reached.
Alarms include:
OUTDOOR TEMPERATURE
OUTDOOR HUMIDITY
LIGHTNING STRIKES (ON/OFF only; ON by default)
RAINFALL
Setup an Alarm
1. Press and release the “
SELECT
” or the “
SELECT
” button until the reading for
which you wish to set an alarm is shown on the display.
2. Press and release the “ALARMS” button until
is shown on the display.
4. Press and release the “
ENTER
SET
” button. If applicable, the current LOW alarm value will
ash on the display.
5. Press and release the “
SELECT
” or “
SELECT
” buttons to adjust the alarm’s LOW value.
6. Press and release the “
ENTER
SET
” button. The current HIGH alarm value will ash on
the display.
7. Press and release the “
SELECT
” or “
SELECT
” buttons to adjust the alarm’s HIGH value.
8. Press and release the “
ENTER
SET
” button to save your adjustments.
9. Repeat steps 1-8, as needed.
Disable an Alarm
1. Press and release the “
SELECT
” or the “
SELECT
” button until the reading for which you
wish to disable an alarm is shown on the display.
2. Press and release the “ALARMS” button until
is shown on the display.
3. Press and release the “
ENTER
SET
” button until the display returns to normal viewing mode.
NOTE: To disable ALL alarms at once, press and HOLD the “ALARMS” button for
5 seconds.