92
Delta System Installation (cont.)
9 Once all home theater addresses are programmed into the Delta-88, repeatedly press
the PRESET button until the source display reads "MODE 3 PRGRM".
10 Press the Delta-88's ALL button. The source display will quickly read
"PROGRAMMING"......"PROGRAMMED".....and then the source name selected to that
room. This downloads all the information to the keypads on the system.
2 Programming the SSD-66 for Home Theaters
The SSD-66 has numerous addresses, several of which are used to tell the SSD-66 which zone
it is operating on. Since Delta-88s are grouped in networks of no more than 16 rooms per
network (16 networks can be incorporated in any one home), only the first sixteen addresses
on the SSD-66 actually apply to rooms. The following chart details the correlation of SSD-66
addresses to zone numbers and Delta room buttons.
Please note, if your Delta-88 incorporates VSM-8 Video Cards or RBM-50 Bass Amp Cards,
which take the place of a zone card, the zone numbers will not necessarily match up. The
imperative is that the SSD-66 address match up with the room button number.
To verify or change the SSD-66's address, follow these steps.
1 Turn the SSD-66 on by pressing the MODE button. If your SSD-66 is not getting AC, also
turn on the room that it is associated to the home theater on the Delta-88.
2 Press the SSD-66's MODE button until its display reads "SETUP MODES".
DELTA ROOM BUTTON # SSD-66 (THX) ADDRESS TYPCIAL ZONE #
1001
2012
3023
4034
5045
6056
7067
8078
9089
10 09 10
11 10 11
12 11 12
13 12 13
14 13 14
15 14 15
16 15 16
To Next Page
Loading...
Need help?
General
