17
| P a g e © Adam Equipment Company 2010
10. OPERATION
10.1. ZEROING
• You can press the [Zero] key at any time to set the zero point from
which all other weighing and counting is measured. This will usually be
necessary when the platform is empty. When the zero point is obtained
the display will show the zero indicator.
• The scale has an automatic re-zeroing function to account for minor
drifting or accumulation of material on the platform. However you may
need to press [Zero] to re-zero the scale if small amount of weight is
still shown when the platform is empty.
10.2. TARING
10.2.1 MANUAL TARE
• Zero the scale by pressing [Zero]. The zero indicator will be on. Place a
container on the platform and its weight will be displayed.
• Press [Tare] when the reading is stable. The weight that was displayed
is stored as the tare value and it is subtracted from the display, leaving
zero on the display. The stable and Net indicator will be on.
• As a product is added only the weight of the product will be shown. The
scale could be tared a second time if another type of product was to be
To Next Page
Loading...
Need help?
General
