23
| P a g e © Adam Equipment Company 2010
10.5.1 SETTING UP WHILE WEIGHING
• Press the [Low Limit] key. It will show the current low limit. The “LO”
symbol will appear on the display.
• Press the [CE] key to clear the old value and then enter the new low
limit using the numeric keys. The decimal point is fixed at the position
that is used for the current weighing unit. When the desired value is
shown press [Tare] to accept the value. If you want to reset the value to
zero, press [CE] to clear the value.
• The limits are displayed in the weighing unit in use.
• To set the high limit press [High Limit], the display will show the high
limit, the “HI” symbol will be on to the left side of the display. Set the
high limit in the same way the low limit was set.
• Pressing the [Tare] key to enter the value will return the scale to
weighing, with the Check-weighing function enabled.
To Next Page
Loading...
Need help?
General
